-
AHA: The question is: Why isn't R3 seeing the LAN interfaces of R1??? Since they where redistributed on EIGRP and then EIGRP was redistributed into OSPF....wouldn't R3 see them??? When you redistribute 2 LAN connected interfaces into EIGRP on...
-
The macro "spanning-tree vlan <vlanid> root primary" configured on sw1 works as follows with only one exception 1. sw1 first tries to be the root bridge by setting its priority equal to the current root bridge(by increasing or decreasing...
-
suporte: interface Serial0/0.102 point-to-point ip address 1.1.1.1 255.255.255.252 snmp trap link-status frame-relay class FRTS <--------------------------------------------- frame-relay interface-dlci 102 service-policy output PARENT To begin with...
-
Gonzalex: It is not however explained in the book (not clearly to me at least), how does the router then decides which "connection" to keep - SPT or RPT? I am assuming it would choose the best one - but how does it decide which is the best?...
-
daniel.dib: Both R4 and R5 were running PPPoFR. They could see each other as CDP neighbors. Hi Daniel We need to enable cdp on virtual-template if PPPoFR is running, in this case it does matter whether cdp is enabled on physical interface or not. But...
-
Did you put the same IP address on both virtual-template 13 and
virtual-template 35? If so, that's the problem. if your hub is only going to have one single IP address, both
dlci's can point to the same virtal-template. Remember, its just a template...
-
No it's not. Also the IOS version is 12.4(15)T. The topology is based off the 360 topology. That's why we built our new racks for the bootcamps to match the 360 topology. Everything I'm telling you I heard from Cisco directly. -- Brian Dennis...
-
I am writing this thread in reply/response one posted in 2009 (http://ieoc.com/forums/p/8929/62670.aspx#62670), which basically asks the difference between the remove and except option in the command switchport trunk vlan pruning vlan. The first question...