Hi,

I only get dynamic mappings to BB1 on DLCI 51 or DLCI 100, not on DLCI 101 as it says to use in the document.

Rack2R6(config-if)#do sh frame map
Serial0/0 (up): ip 54.2.2.254 dlci 100(0x64,0x1840), dynamic,
broadcast,, status defined, active
Serial0/0 (up): ip 54.2.3.254 dlci 51(0x33,0xC30), dynamic,
broadcast,, status defined, active
Rack2R6(config-if)#

This is using InternetworkExpert racks.

I haven't looked at BB1's config to see if this makes sense,
but thought I would post it in case someone else has the same problem.

BR
Toby