Hi,

I have configured the task 2.8 in the same way that solution guide.
But i have configured the TEST-PC on vlan 92 with ip 192.10.X.105
Then i have started a ping from R5 to the NAT 136.X.59.100 and looked at show service-policy to see the packets increasing on OUTSIDE policy.
Nothing happens.
I have tried every possible combination of ACL (IP, ICMP ALL, source and destination ANY, everything, and nothing happens)
Then i have the idea to apply the policy on the inside interface and rate-limit the output.
Than the solution works!
Now become the question, if this problem is specific to this software version or the PIX donīt rate-limit input (And if this is true, why we have the command police input?

Regards,
Rafael M. Koike